Siemens SCALANCE W1780 Configuration Manual page 325

● HTTPS
Specify whether the station (or the IP address) accesses the device using the HTTPS
protocol.
● SSH
Specify whether the station (or the IP address) accesses the device using the SSH protocol.
● Px
Specify whether the station (or the IP address) accesses the device via this port.
● VAP X.Y
Specify whether the station (or the IP address) accesses the device via the VAP interface.
● WDS X.Y
Specify whether the station (or the IP address) accesses the device via the WDS interface.
Procedure
Note
Note that a bad configuration may mean that you can no longer access the device.
You can then only remedy this by resetting the device to the factory defaults and then
reconfiguring.
Changing the entry
1. Configure the data of the entry you want to modify.
2. Click the "Set Values" button to transfer the changes to the device.
Creating new entry
1. In the "IP Address" input box, enter the IP address of the device and in the "Subnet Mask /
Prefix Length" input box the corresponding subnet mask.
2. Click the "Create" button to create a new row in the table.
3. Configure the entries of the new row.
4. Click the "Set Values" button to transfer the new entry to the device.
Deleting entries
1. Select the check box in the row to be deleted.
2. Repeat this procedure for every entry you want to delete.
3. Click the "Delete" button. The entries are deleted and the page is updated.
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03
Configuring with Web Based Management
6.10 "Security" menu
325