Siemens SCALANCE W1780 Configuration Manual page 89

● Create entries with "Create"
Pages in which you can make new entries have a "Create" button at the lower edge. Click
this button to create a new entry.
● Delete entries with "Delete"
Pages in which you can delete entries have a "Delete" button at the lower edge. Click this
button to delete the previously selected entries from the device memory. Deleting also
results in an update of the page in the WBM.
● Page down with "Next"
The number of data records that can be displayed on a page is limited. Click the "Next"
button to page down through the data records.
● Page back with "Prev"
The number of data records that can be displayed on a page is limited. Click the "Prev"
button to page back through the data records.
● Delete the display with "Clear"
In pages with sequence logs, you can delete all table entries at the same time regardless of
whether filters are selected. The display is cleared in this process. The restart counter is only
reset after you have restored the device to the factory settings and restarted the device.
Click the "Clear" button to completely delete the data set.
● Button "Show all"
You can show all entries in pages with a large number of data sets. Click "Show all" to
display all entries on the page. Note that displaying all messages can take some time.
● Drop-down list for page change
In pages with a large number of data records, you can navigate to the desired page. From
the drop-down list, select the affected page to display it.
● "Reset Counters" button
Click "Reset Counters" to reset all counters. The counters are reset by a restart.
Messages
If you have enabled the "Automatic Save" mode and you change a parameter the following
message appears in the display area "Changes will be saved automatically in x seconds. Press
'Write Startup Config' to save the changes immediately."
Note
Interrupting the save
Saving starts only after the timer in the message has elapsed. How long saving takes depends
on the device.
During the save, the message "Saving configuration data in progress. Please do not switch off
the device" is displayed.
● Do not switch off the device immediately after the timer has elapsed.
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03
Configuring with Web Based Management
6.4 "Information" menu
89