Windows Settings For Use As Default Router - Siemens SIMATIC TS Adapter IE Manual

7.14

Windows Settings for Use as Default Router

Windows settings
Make the following settings on your PG/PC. The instructions are based on the example of
Windows XP Professional.
1. Open the Control Panel by clicking "Start > Control Panel" or "Start > Settings > Control
2. Double-click "Network Connections".
3. Double-click the network connection by which your PG/PC is connected to the
4. Click "Properties...".
5. Select "Internet Protocol (TCP/IP)" from the list and click "Properties".
6. Check the "Use the following IP address" check box.
7. Enter the IP address of your PG/PC's network adapter. This IP address must be in the
8. Enter the same subnet mask you assigned to the TS Adapter IE.
9. Under "Default gateway:" enter the IP address you assigned to the TS Adapter IE.
10. Check the "Use the following DNS server addresses" check box.
11. Under "Preferred DNS server:" again enter the IP address you assigned to the
12. Close all open windows by clicking "OK" or "Close".
Result
When you have set these parameters, your browser accesses the Internet via the
TS Adapter IE.
TS Adapter IE
Manual, 11/2010, A5E00977705-03
Panel".
TS Adapter IE.
The "Status of ..." dialog box opens.
The "Properties of ..." dialog box opens.
The "Properties of Internet Protocol (TCP/IP)" dialog box opens.
same subnet as the IP address you assigned the TS Adapter IE.
TS Adapter IE.
Note
Your browser must be configured to not use a proxy server. You can check this in
Internet Explorer 6.0, for example, as follows:
1. Select "Tools > Internet Options ...".
2. In the "Internet Options" dialog box, select the "Connections" tab and click "LAN
Settings".
3. Clear all check boxes.
4. Close the open windows by clicking "OK".
Working with the TS Adapter IE
7.14 Windows Settings for Use as Default Router
61