Hc Root Hub Status Register (Hcrhstatus); Hc Root Hub Status Register (Hcrhstatus) Field Descriptions - Texas Instruments TMS320C6747 DSP User Manual

Registers

3.21 HC Root Hub Status Register (HCRHSTATUS)

The HC root hub status register (HCRHSTATUS) reports the USB1.1 host controller root hub status.
HCRHSTATUS is shown in
31 30
CRWE
R/W-0
15 14
DRWE
R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 22. HC Root Hub Status Register (HCRHSTATUS) Field Descriptions
Bit Field Value
31 CRWE
0
1
30-18 Reserved 0
17 OCIC
0
1
16 LPSC 0
15 DRWE
0
1
14-2 Reserved 0
1 OCI 0
0 LPS 0
30 Universal Serial Bus OHCI Host Controller
Figure 22 and described in
Figure 22. HC Root Hub Status Register (HCRHSTATUS)
Reserved
R-0
Reserved
R-0
Description
Clear remote wake-up enable.
No effect..
Clears the device remote wake-up enable bit.
Reserved
Overcurrent indication change. This bit is automatically set when the overcurrent indicator bit changes.
This bit has no relationship to the OTG controller register bits that relate to VBUS. System software can
update this register to simplify host controller driver and/or OTG driver coding.
No effect.
Clears this bit.
Local power status change. Because the root hub does not support the local power status feature, this
bit defaults to 0 and has no effect. This bit has no relationship to the OTG controller register bits that
relate to VBUS. System software can update this register to simplify host controller driver and/or OTG
driver coding.
Device remote wake-up enable.
When 1, this bit enables a connect status change event to be treated as a resume event, which causes
a transition from USB suspend to USB resume state and sets the resume detected interrupt status bit.
When 0, connect status change events do not cause a transition from USB suspend to USB resume
state and the resume detected interrupt is not changed.
A write of 0 has no effect.
A write of 1 sets the device remote wake-up enable bit.
Reserved
Overcurrent indicator. Because the device does not provide signals for external hardware to report
overcurrent status to the USB1.1 host controller, this bit is always 0. This bit has no relationship to the
OTG controller register bits that relate to VBUS.
Local power status. Because the root hub does not support the local power status feature, this bit
defaults to 0 and has no effect. This bit has no relationship to the OTG controller register bits that relate
to VBUS. System software can update this register to simplify host controller driver and/or OTG driver
coding.
Table 22.
Submit Documentation Feedback
www.ti.com
18 17 16
OCIC LPSC
R/W-0 R/W-0
2 1 0
OCI LPS
R-0 R/W-0
SPRUFM8 – June 2009