Front Passenger Seats; Doors; Driver Seats - Chevrolet 10 1971 Series Chassis Service Manual

BODY 1-28
Fig. 72— Body Mount N o . 2
stripping. The sides of the tail gate are sealed by a
weatherstrip on the inside of the body opening. The bot­
tom of the tail gate is sealed by a weatherstrip which is
glued across the bottom of the tail gate itself as shown
in Figure 65.

DOORS

Since the front doors on Blazer models do not incor­
porate door windows or ventipanes, a cover plate is in­
stalled over the opening where these components would
normally be installed as shown in Figure 66.
On those Blazers which do incorporate door windows
and ventipanes,the Service procedures outlined in the
section on Conventional Models are applicable.
On either the open or closed Blazer model, the ends of
the door opening weatherstrip are sealed at the door
pillar and at the windshield header as shown in Fig­
ure 67.
SEATS

Driver Seats

Both the standard seat and the optional driver's bucket
seat mount as shown in Figure 68. Torque mounts to
specifications.

Front Passenger Seats

The optional auxiliary seat (fig. 69) and the optional
passenger bucket seat (fig. 70) are mounted differently
due to mounting bracket design differences. Torque all
parts to specifications.
Rear Seat
The optional rear seat is shown in Figure 71.
After removing the rear seat, reinstall
NOTE:
the bolts into the anchor nuts to seal the open­
ings from dirt and foreign matter. When re­
installing the seat, torque all hold-down bolts
to specifications.
The rear seat option also includes two seat belts and a
rubber rear compartment floor mat. If removing the rear
seat temporarily—to haul cargo, for instance—it is not
necessary to remove the seat belts from their anchor­
ages as they attach to the rear seat support.
REAR COMPARTMENT FLOOR MAT
Removal and Installation
1. Lower tail gate.
2. Remove the spare tire and its mounting bracket.
3. Remove the rear seat.
4. Remove the front and rear floor mat scuff plates.
5. Remove the floor mat.
6. Reverse Steps 1-5 to reinstall the floor mat.
BODY A N D PICK-UP BO X M O U N T IN G
Refer to the section on Conventional
NOTE:
Models for Body Mount #1. Mounts two, three,
four, and five are as shown in Figures 72 and 73.
10-30 CHEVROLET TRUCK SERVICE MANUAL