Installation
1. Transfer remote rod with clipkof new lock.
2. Connect remote door handle rod to lock after lock is
positioned.
3. Secure lock screws.
4. Secure remote handle.
5. Check all controls for proper operation before rein
stalling trim and handles.
6. Install remote control sill knob.
7. Adjust striker as outlined under "Front and Rear
Door Lock Striker Adjustment".
Front Door Lock Cylinder Assembly
Removal and Installation
1. Raise door window and remove door trim pad.
2. With a screw driver, or other suitable tool, slide
lock cylinder retaining clip (on door outer panel) out
of engagement and remove lock cylinder (fig. 37).
3. To install, reverse removal procedure.
Fig. 39— Remote Control and Side Rear Door Lock.
Front Door Lock Remote Control and Connecting Rod
The remote control is secured to the door inner panel
by the three attaching bolts.
Removal and Installation
1. Raise door window and remove door trim pad.
2. Remove bolts securing remote to door inner panel.
3. Pivot remote inboard slightly, to disengage connect
4.
REAR SIDE D O O R -P A N E L A N D SUBURBAN LOCK
Removal and Installation (Fig. 39)
1. Wind window glass to closed position.
2. Remove control knobs and trim assembly.
3. Remove three (3) screws from the door end - at the
ing rod, and remove remote control from door.
To install, reverse removal procedure.
Connecting rod can be removed at this
NOTE:
point by disconnecting spring clip from lock.
rotor lock.
BODY 1-15
10-30 CHEVROLET TRUCK SERVICE MANUAL