BODY 1-32
Begin with operation 4 and continue through oper
ation 12.
DRIVER'S W IN D O W THUMB PULL A N D
LOCKING DEVICE
Installation
1. Attach driver' s window thumb pull and latch assem
bly to glass using .040 x 2-1/4" glass glazing strip
or its equivalent. Center the latch on leading edge of
glass.
Fold the glazing strip over edge of glass,
apply No. 30 weight motor oil on the outside of the
glazing strip and press latch onto the glass. If it is
necessary to use mallet or hammer to position latch,
tap lightly. Too hard a blow could chip or break
glass or cause the clip to open up slightly thus re
ducing the grip on glass. The glazing strip should be
allowed to setup a few hours before too much pres
sure is applied to it.
10-30 CHEVROLET TRUCK SERVICE MANUAL