Chevrolet 10 1971 Series Chassis Service Manual page 146

REAR SUSPENSION AND DRIVE LINE 4-26
2. Place front trunnion in drive shaft. Place center
yoke on front trunnion. Install one bearing cup and
seal assembly in front yoke. Drive in to a depth
that the snap ring can be installed. Install snap ring.
Install remaining cup and seal in front yoke. Install
snap ring.
3. Install front trunnion bearing cups in center yoke in
same manner.
4. With front trunnion completely installed, install seal
on prop shaft (large face first). Gently slip rear
yoke half on prop shaft using care not to upset
rollers. Insert rear trunnion in center yoke. Install
rear yoke half bearing caps on rear trunnion. Install
one rear trunnion bearing cap in center yoke and
press into yoke until snap ring can be installed. In­
stall remaining cap and snap ring.
5. Grease universal as outlined in Section 0 at all
three (3) fittings (2 conventional type and one (in
rear yoke half) ) that requires a needle nose grease
gun adapter).
6. Install propeller shaft with constant velocity joint
next to transfer
specifications.
case. Torque U-bolts
Fig. 54— Rear Surpension Special Tools
to
1. J-7079-2 Driver Handle
2. J-7574-6 Series C20 Tie Rod Bushing Insi-a11er
3. J—851 8 Series C -P lO T ie Rod Bushing I nstal I er
4. J-8118 Rear Spring Pin Puller (Used with J—261 9)
5. J-8448 Series C -P lO a n d C -3 0 Control Arm
Bushing Installer
10-30 CHEVROLET TRUCK SERVICE MANUAL