BODY 1 -6
Fig. 10— Pulling String to Seal Rubber Tip
Arm Adjustment
To adjust sweep of blades, turn on wipers and note
sweep of arms.
If necessary, remove one or both arms
as follows: Pull outer end of arm away from glass which
will trip lock spring at base of arm and release spring
from undercut of pivot shaft. While holding arm in this
position, pull outward on cap section at base of arm to
remove arm.
Arm can be reinstalled in any one of
Fig. 13— Instrument Panel Cover
Fig. 11— Rear View Mirrors
Fig. 14— Cowl Ventilator G rille Intake - Cab M odels
10-30 CHEVROLET TRUCK SERVICE MANUAL