CHASSIS SHEET METAL 11-4
Refer to appropriate sections of this manual for
instructions.
Shims which are found at various locations should be
recorded to ease installation of sheet metal assembly.
Proceed as follows:
10 THROUGH 30 SERIES (Except Step Vans)
Removal
1. Drain radiator and remove radiator hoses. Discon
Fig. 7— Fender to Body Attachments
nect oil cooler lines if so equipped.
2. Disconnect wire connectors at the dash and toe panel
and wire connector to horn and voltage regulator.
3. Disconnect battery and generator wires.
4. Remove reinforcement on left fender skirt at steer
ing column.
5. Remove front bumper bolts and remove bumper.
6. Remove wiper arm assemblies and cowl grille.
10-30 CHEVROLET TRUCK SERVICE MANUAL