Chevrolet 10 1971 Series Chassis Service Manual page 216

ENGINE 6-38
With Small V8 Engines
1. Remove distributor cap.
2. Remove mount retaining bolt from below frame
mounting bracket.
3. Raise front of engine and remove mount-to-engine
bolts and remove mount.
Raise engine only enough for suf­
CAUTION:
ficient clearance. Check for interference be­
tween rear of engine and cowl panel.
4. Replace mount to engine and lower engine into place.
5. Install retaining bolt
specifications.
With Mark IV V8 Engine
1. Remove cotter keys then loosen front mount bolt.
2. Raise engine enough to remove weight from cushions.
0
(« )
F R O N T
o
' ® ®
• S M A L L V 8 '
and torque all bolts
C Y L I N D E R H E A D T O R Q U E S E Q U E N C E
S M A L L V 8 "
I N T A K E M A N I F O L D T O R Q U E S E Q U E N C E
0
® /
° '
JP
®l
Fig. IT — Torque Sequence
3. Remove nut, bolt, spacer and cushions and reinstall
with new cushions.
4. Lower engine and torque bolt to specifications.
5. Install cotter key.
Rear Mount Replacement
1. Support engine weight to relieve rear mounts.
2„ Remove mount attaching bolts from frame outrigger
and clutch housing
cushions.
3. Install new mounting cushions and bolts.
4. Lower engine onto mounts.
to
5. Torque bolts to specifications then bend lock tabs
to bolt head.
L6
and remove rear mounting
•MARK IV V 8 "
' M A R K I V V 8 J
10-30 CHEVROLET TRUCK SERVICE MANUAL