Chevrolet 10 1971 Series Chassis Service Manual page 307

VIEW B
FLUID LEVEL INDICATOR
The fluid level indicator is located in the filler pipe at
the right rear corner of the engine. To bring the fluid
level from the add mark to the full mark add 1 pint.
Fluid level should be to the full mark with transmission
at normal operating temperature. With cold fluid the
level should be 1/4 inch below the add mark.
SHIFT CONTROL LINKAGE ADJUSTMENT
Adjust linkage as described below:
COLUM N SHIFT
1. The shift tube and lever assembly must be free in
the mast jacket. See Section 9 for alignment of
steering column assembly if necessary.
Fig. 3T— Lower Control Linkage (PS-PE-20-30 Models)
CLUTCHES AND TRANSMISSIONS 7-31
2. To check for proper shift linkage adjustment, lift the
transmission selector lever towards the steering
wheel. Allow the selector lever to be positioned in
drive (D) by the transmission detent,
Do not use indicator pointer as a
NOTE:
reference to position the selector lever. When
performing linkage adjustment, pointer is ad­
justed last.
3. Release the selector lever. The lever should be
inhibited from engaging low range unless the lever
is lifted.
4. Lift the selector lever towards the steering wheel
and allow the lever to be positioned in neutral
the transmission detent.
VIEW A
by
(N)
10-30 CHEVROLET TRUCK SERVICE MANUAL