CHASSIS SHEET METAL 11-6
Fig. 10— Running Board— CA310-360 (04) Models
7. Disconnect fan shroud and lay back on engine.
8. Remove both head lamp assemblies. Complete.
9. Remove left fender gusset (5 screws).
10. Remove screws securing fender skirts to radiator
support bottom.
11. Remove bolt securing center grille support to radia
tor support.
12. Remove bolts securing hood catch assembly to radia
tor support.
13. Remove radiator support bolts secured to frame--
Note and record stackup.
14. Tilt radiator support rearward and lift up and off.
Installation
1. Rotate radiator support into position and loosely in
stall attachments to frame.
2. Connect center grille support to radiator support.
3. Connect hood latch plate.
4. Connect left radiator support gusset to left fender.
5. Connect support to left fender.
6. Connect 3 screws from underside of left skirt to
support bottom.
7. Place right fender in position and loosely install
bolts and shims at fender top to cowl.
8. Attach grille upper to right fender bolts loosely.
9. Attach bolts from inside of grille lower to right
fender lower (limited access between radiator sup
port outer face and grille inner face).
10. Install radiator support to fender.
11. Using drift line up right fender skirt rearmost bot
tom screw with fender flange and attach loosely.
12. Attach right fender skirt inner top bolts to fender
underside.
13. Install screw from underside of skirt to center of
fender flange.
14. Tighten rearmost bottom screw offender skirt pre
viously installed loosely.
15. Install remainder of skirt to right fender screws
snugly.
16. Tighten right fender skirt front 3 bolts from under
side to radiator support.
17. Place battery tray in position and fasten to radiator
support.
18. From beneath skirt fasten screw to battery tray
bottom.
19. Install bolt and shim at bottom of front fender rear
to hinge pillar loosely.
20. Tighten 6 grille filler panel screws previously at
tached to radiator support.
21. Install radiator, hoses and shroud.
22. Connect removed wiring to radiator support.
23. Install both head lamp assemblies.
24. Tighten all previously installed bolts and screws,
attached.
27. Install hood on previously marked outline.
28. Install and secure cowl grille.
25. Install battery and connect leads and wires.
26. Fill radiator with coolant as specified in Section 13.
FRONT FENDER
Removal
1. Remove windshield wiper arms, cowl grille and at
taching screws.
2. Remove hood and hinge assembly.
3. Remove head lamp bezel, wiring and attachments
from fender.
4. Remove screws attaching fender wheel opening flange
to skirt.
5. Remove (2) skirt to fender bolts, located inboard on
underside of skirt.
6. Remove two screws attaching gusset to fender.
FRAME
Fig. 11— Running Board and Braces
FRAME SIDEMEMBER
10-30 CHEVROLET TRUCK SERVICE MANUAL