7. Remove two screws attaching radiator support to
front fender.
8. Remove four bolts attaching radiator grille to fender.
9. Remove bolt and shim attaching trailing edge of
fender to hinge pillar.
10. Remove two bolts and shims at top rear of fender
attaching to cowl.
Installation
To install, reverse the removal procedure using seal
ing tape between filler panel and fender. Check sheet
metal alignment.
FRONT FENDER A N D SKIRT (FIGS. 9, 10, 11)
Removal
1. Remove windshield wiper arms.
2. Remove cowl grille and attaching screws.
3. Remove hood and hood hinge assembly.
4. Disconnect battery and remove (right side only) or
remove skirt reinforcement at steering column (left
skirt only).
5. Remove (2) top rear fender bolts and shims.
6. Remove bolt and shims at bottom of fender.
7. Remove bolt and shim(s) attaching skirt to sill
extension.
8. Remove (4) screws attaching head light door to
fender and grille.
9. Remove screws attaching gusset to radiator support.
10. Remove
(3)
screws
support.
11. Remove (2) screws securing fender to radiator
support.
12. Remove (4) screws securing fender to grille.
13. Lift fender and skirt assembly from truck.
Installation
1. Replace fender and skirt assembly.
attaching skirt to radiator
2. Install bolts loosely.
3. Install shims and secure all parts in reverse order
of removal.
4. Tighten shimmed bolts.
FRONT FENDER SKIRT (FIGS. 10 & 11)
Replacement
To replace the skirt alone, remove required screws
and rotate over tire. Reverse procedure to install.
R U N N IN G BOARDS
Refer to Figures 12 and 13.
CHASSIS SHEET METAL 11-7
10-30 CHEVROLET TRUCK SERVICE MANUAL