Chevrolet 10 1971 Series Chassis Service Manual page 433

General Description ................................................................................... 14-1
Service Procedures - 10 thru 30 Series, Except P20-30 .......................
Front Bumper - C and K Models .........................................................
All 1971 truck front and rear bumpers are of a single
piece design. Bumper attachments are the standard
bracket and brace to frame mountings. This section
SERVICE PRO CEDU RES-10 THRU 30 SERIES
FRONT B U M P E R -C A N D K MODELS (Fig. 1)
Removal
1. Remove parking lamp assemblies. (See Section 12).
SECTION 14
BUMPERS
IN D E X
Page
Rear Bumper - C and K M o d e ls ................ ........................................... 14-1
14-1 Front Bumper - P20 and 30 Models
14-1
GENERAL DESCRIPTION
contains procedures for the removal and installation of
face bars, brackets, braces and license plate brackets,
2. Remove bolts securing left and right bumper braces
3. Remove bolts securing two bumper brackets to
4. Remove bolts securing bumper face bar to frame,
5. If necessary, disassemble bumper by removing bolts
Installation
Assemble and install front bumper following the re­
moval procedure in reverse order. Refer to torque
specifications in rear of manual for correct torque
values.
REAR BU M P ER -C A N D K MODELS (Fig. 2)
Removal
1. Remove bolts attaching bumper to each bumper
2. Remove bolts attaching bumper to frame.
................................................... 14-2
to frame.
frame.
and remove bumper from vehicle.
attaching brackets and braces to bumper face bar.
brace. Disconnect license lamp wiring on suburban
and panels and pickup.
Page
10-30 CHEVROLET TRUCK SERVICE MANUAL