Installing Sliding Glass; Installing Stationary Glass - Chevrolet 10 1971 Series Chassis Service Manual

BODY 1-30
Fig. 75— Driver's Window Weatherstrip
weatherstrip rubber. Place paint scraper or simi­
lar object on top of glass and into channel - pry down
and push top of glass into channel. Push glass for­
ward as far as possible (fig. 76).
4. Set lower edge of stationary glass in weatherstrip
Fig. 7 6 — Installing Slidin g G lass
Fig. 77— Installing Stationary Glass
between the run channel and inside edge of rubber.
Keep rear edge of glass ahead of weatherstrip at
rear of window opening. Using the tool shown in
Figure 77 or similar instrument work glass into the
weatherstrip channel.
5. Work top of stationary glass into weatherstrip chan­
nel in same manner as the bottom.
6. Use rubber mallet to tap glass back to the weather­
strip. Work into weatherstrip channel using paint
scraper or similar tool and rubber mallet (fig. 78).
Tap glass firmly into weatherstrip.
7. From the outside of the door work the run channel
ends into weatherstrip rubber with the paint scraper
and mallet handle to tap them back. Channel ends
are shown in Figure 75.
10-30 CHEVROLET TRUCK SERVICE MANUAL