Push Button Assembly; Endgate Centerlock; Endgate Side Lock; Front Door Assembly - Chevrolet 10 1971 Series Chassis Service Manual

BODY 1-10
VIEW A
2. Remove spring clip securing the right side lock rod
to remote assembly. (See Figure 26)
3. Remove screws securing the remote and push button
control assembly plate.
4. Pull out the remote and push button control assembly
to remove the left side lock rod spring clip: (See
Figure 27)
5. Hold the center lock spring lever out of the way and
remove the control assembly.
6. Reverse the procedure to install.

Push Button Assembly

If necessary to remove the push button assembly, apply
the above Remote and Push Button Control steps and
proceed as follows:
1. Secure the Remote and Push Button Control Assembly
and remove two screws from the back of the plate.
2. Rotate the push button assembly to release the lock
assembly and remove.
3. Reverse procedure to install.
Adjustment
Elongated holes with two large screws and external
tooth washers are provided in the remote and push button
control assembly plate to provide for needed adjustment.
Lock Cylinder Escutcheon
Removal and Installation
1. Apply above Remote and Push Button Assembly Re­
moval procedures.
2. Remove two nuts securing the escutcheon.
3. Remove escutcheon and gasket.
4. Reverse procedure to install.
VIEW D
NOTE: Assemble center lock in
position & tighten adjusting
Screw until it contacts lever
on the Remote Control Asm.
Fig. 25-Suburban Endgate Assembly

Endgate Centerlock

1. Remove screws from endgate end.
2. Remove centerlock assembly.
3. Reverse above procedure to install.

Endgate Side Lock

1. Remove Remote and Push Button Assembly mechan­
2. Remove right or left side lock rod spring clip.
3. Remo 'e four (4) screws and lock washers.
4. Guide rod and side lock from endgate.
5. Reverse procedure to install.
PANEL A N D SUBURBAN ENDGATE, LIFTGATE
A N D REAR DO OR STRIKERS— ADJUSTMENT (Fig. 28)
in Figure 28. Adjust for dimensions shown and add
spacers as required. For rear door, adjust wedge as
shown in Figure 47.
FRONT DO O R ASSEMBLY (Fig. 29, 30)
Replacement
the hinges from the door.
Adjustment
the hinge straps-to-door panel and at the hinge cage-to-
pillar. Before adjustment is made on any door, however,
the striker plate should be removed. The door can be
moved fore, aft, up and down at the hinge pillar and the
door also can be moved in or out at the hinge-to-door
panel. However, in order to adjust the cab front side door
assembly at the body hinge pillar it is necessary to use
VIEW C
ism access hole cover.
Locations for striker adjustment are typically shown
Remove the door assembly from the body by removing
Door adjustment may be accomplished at two places; at
VIEW B
10-30 CHEVROLET TRUCK SERVICE MANUAL