4 - 14 FX Series RFID Readers Integrator Guide
Configure Reader
Use the
Configure Reader
Reader Parameters (General)
Select
in the selection menu to configure reader settings using this window.
General
Configure Reader
Figure 4-15
•
- Sets the reader name. Accepts up to 32 alphanumeric characters.
Name
•
- Describes the reader. Accepts up to 32 alphanumeric characters.
Description
•
- Provides information on the reader location. Accepts up to 32 alphanumeric characters.
Location
•
- Name of the reader manager contact. Accepts up to 32 alphanumeric characters.
Contact
•
Operation Status
•
Antenna Check
not attempt to check if an antenna is connected on the ports. When
presence of an antenna on the port and only transmits RF if an antenna is connected.
•
Set Properties
These settings only affect the display. Use
submenus to access the following functions.
- Displays the reader current operation status (
- Controls the antenna sensing feature on the reader.
- Sends the changes to the reader.
Commit/Revert on page 4-32
,
, or
Enabled
Disabled
Unknown
indicates that the reader does
Disabled
, the reader monitors the
Enabled
to save the changes.
).