Chapter 3 Installation And Communication; Introduction; Unpacking The Reader - Motorola FX7400-22350A30-US Integrator Manual

Chapter 3 Installation and Communication

Introduction

This chapter includes the following FX Series RFID reader installation and communication procedures:
•
Unpacking the Reader on page 3-1
•
Mounting and Removing the Reader on page 3-2
• Mounting Tips on page 3-2
• Mounting Using the Mounting Plate on page 3-2
• Direct Mounting (Without the Mounting Plate) on page 3-3
•
Connecting Antennas on page 3-4
•
Communications Connections on page 3-5
• Ethernet Connection on page 3-5
• USB Connection on page 3-6
•
Powering the Reader on page 3-6
• Powering the Reader via AC Power Supply on page 3-6
• Powering the Reader via Power-over-Ethernet (POE) on page 3-7
•
System Start-up/Boot LED Sequence on page 3-7
The FX Series RFID readers must be professionally installed.
CAUTION
!
WARNING

Unpacking the Reader

Remove the reader from the shipping container and inspect it for damage. Keep the shipping container, it is the
approved shipping container and should be used if the reader needs to be returned for servicing.
For Mounting in Environmental Air Handling Space (EAHS): Any Cables used to interconnect
to other equipment must be suitable for use in EAHS as per UL2043.