Connecting Cables; Connecting Network Cable; Installing The Sfp/Sfp+ Transceiver Module And Optical Fibers - H3C S1200 Series Getting Started Manual

To mount the switch under a table:
Follow the instructions on wall mounting to determine the location of screw holes to be used for
1.
under-table mounting.
Align the two mounting holes in the switch chassis bottom with the two screws on the bottom of
2.
the table and hang the switch.
Use a third screw to prevent switch movement.
3.
NOTE:
Installation hole spacing varies by switch model. For more information, see

Connecting cables

Connecting network cable

Use crossover cable or straight through cable to connect a PC or other network devices to the
Ethernet port of the switch.
Figure 12 Connecting network cable
Installing the SFP/SFP+ transceiver module and optical
fibers
CAUTION:
• Hold the SFP/SFP+ transceiver module by its two sides when you install or remove the module.
Do not touch the golden plating of the module.
• Remove the optical fiber, if any, from a transceiver module before installing it.
To install an SFP/SFP+ transceiver module and optical fibers:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Pivot the clasp of the module up. Holding the module, gently push the module into the slot until
2.
it has firm contact with the slot (when the top and bottom spring tabs catch in the slot).
Remove protective sleeves from optical fibers, and the dust plug from the transceiver module.
3.
Connect the LC connectors of the optical fibers to the transceiver module.
4.
9
Table 4.