Replacing Or Adding Dual Inline Memory Modules; Capacity - Avaya CallPilot 1002rp Maintenance And Diagnostics

11. Press Ctrl+Alt+Delete to reboot the CallPilot server.
12. During the reboot sequence, check the version of the BIOS on the top of the first
To configure the Pentium III SBC
1.
2. Set the MPS 1.4 Support value to Disabled in the Chipset menu.
3. Press F9 to accept the other default values.
4. Press Enter when prompted to confirm this change.
5. Press F10 to save and exit the BIOS setup.
6. Restart the server.

Replacing or adding dual inline memory modules

The DIMMs are located on the SBC. The gold-plated edge connectors on DIMMs are designed
to plug into matching edge-connector slots. The design allows you to add or remove these
modules repeatedly without tools or without causing damage. Install DIMMs on the SBC only.

Capacity

The base CallPilot has one 512-Mbyte DIMM installed in Bank 1. Another 512-Mbyte DIMM
can be installed in Bank 2 for total memory of 1 Gbyte. No other memory configurations are
supported on this server.
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Result: The CallPilot server reboots.
screen. The BIOS version must be NNCXUA07.
Tip: If the BIOS version is not NNCXUA07, then check if the J10 and J11 jumpers
are both in the top position. Power down the server, remove the single board
computer (SBC) board and set the jumpers to the correct position. Follow the
electrostatic discharge (ESD) rules to prevent static electricity from damaging the
SBC board.
Caution:
Risk of data loss
Perform this procedure only if specifically instructed to do so by your Avaya
representative.
Restart the server, and then press Delete to enter Setup when prompted.
Result: BIOS reconfiguration is completed.
Replacing or adding dual inline memory modules
December 2010 143