Table of Contents
Advertisement
2. At the Command prompt, type net stop "service_name", and then press Enter.
3. Type Exit, and then press Enter to exit the Command Prompt window.
Service Control (SC) command
Use the Service Control command to stop a specified service on a serial port.
Service Control command syntax
The Service Control command uses the following syntax:
sc <service_name>
Important:
You must restart the services that you shut down through the Service Control command after
you run the diagnostic. For details, see
To invoke the Service Control command from Windows
1. Click Start → Programs → Accessories → Command Prompt.
2. At the Command prompt, type sc stop "service_name", and then press Enter.
3. Type Exit, and then press Enter to exit the Command Prompt window.
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Result: The Command Prompt window appears.
Example: Type net stop "Remote Access Server", and then press Enter.
Note:
The quotation marks are required, as in the example above.
Result: The system runs the Net Stop command utility.
Result: The Command Prompt window appears.
Example: Type sc stop "Remote Access Server", and then press Enter.
Note:
The quotation marks are required, as in the example above.
Result: The system runs the Service Control command utility.
Restarting services
on page 45.
Service Control (SC) command
December 2010
41
Advertisement
Table of Contents
