Avaya CallPilot 1002rp Maintenance And Diagnostics page 113

9. Select Objects → Channel and press Enter. Ensure that the values are set as
10. In the Configure menu, select New Configuration. Press Yes to proceed.
11. Create the first logical drive by selecting A01-01 (first drive from channel 0), to
12. Press Enter to create the first logical drive.
13. Repeat the process for the second and third logical drives to create packs as follows:
14. Press Enter or F10 to configure the logical drives.
15. Press the space bar to Select Configuration Array. Span-1 appears in the box
16. Configure logical drive A01, by pressing F10.
17. Highlight Accept and press Enter to accept these new values. Repeat for the two
18. Highlight YES and press Enter.
19. Press ESC twice to exit the submenus.
20. In the Management menu choose the Initialize submenu.
21. Press F2 to select all three logical drives.
22. Press F10 and consecutively select YES to initialize the drive packs.
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Note:
The Coercion Algorithm must be set properly. Once changed, it cannot be
changed again. The only way to reset it is to reconfigure RAID from scratch and
load the default configuration, then reboot.
follows:
Termination State: Enabled SCSI Transfer Rate: 160M
Result: The system should display both SCSI channels, each having three drives.
SCSI ID's should be listed in order from 0 to 2 for each channel, starting from the
top. All disk drives should be in READY state.
Note:
Do not use the Load command on the Configure menu. This command is not for
RAID operations.
A01-02 (first drive from channel 1) and pressing the space bar.
Result: After selection, the drives will blink.
A02-01 and A02-02 as second pack
A03-01 and A03-02 as third pack
opened for A01 logical drive. DO NOT select and press the space bar for the other
logical drives at this point.
RAID 1: Size: accept the size display Accept SPAN = NO
remaining logical drives.
Result: After the last logical drive, the system will prompt you to save the
configuration.
Configuring the RAID controller after a hardware change
December 2010 113