Table of Contents
Advertisement
Replacing media drives
4. Slide the new drive into the media drive carrier, and secure it with the screws that
5. Reattach any media drives that you removed to access a specific media drive slot.
6. Position the media drive carrier in the media drive bay, leaving enough room to
7. Carefully connect the existing signal and power cables as shown in
8. Slide the carrier into the media drive bay.
9. Secure the media drive carrier to the chassis with four Phillips-head screws.
10. Replace and lock the front bezel.
Installing a tape drive
This procedure provides instructions for installing a tape drive on a server that currently does
not have a tape drive.
106
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
were previously removed.
reach behind the carrier, and attach the connectors.
Cabling example
on page 107.
Note:
If your tape drive is a narrow device, you require a wide-to-narrow adapter to
connect to the wide SCSI cable.
Note:
Ensure that the cables are free and undamaged.
Figure 28:
December 2010
Advertisement
Table of Contents
