Avaya CallPilot 1002rp Maintenance And Diagnostics page 95

4. Loosen the four Phillips-head screws that secure the status display panel to the
Figure 21: Status display panel.
5. Label and remove the 40-pin flat cable from the back of the status display panel.
6. Move the defective status display panel towards the back of the chassis, and then
7. Set the replacement status display panel into position, and secure it to the chassis
8. Reconnect the cable.
9. Replace the top cover and front bezel.
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
The cooling fans block the access to the status panel.
front of the chassis (see A in
lift it out of the chassis (see B and C in the diagram).
by replacing the Phillips-head screws.
Replacing the status display panel
Figure 21: Status display panel. on page 95)
December 2010 95