Avaya CallPilot 1002rp Maintenance And Diagnostics page 108

Replacing media drives
4. Enable Termination power (TPWR).
5. Leave the remaining settings at the default values.
To install a new tape drive (no tape drive previously installed)
1.
2. Ensure that the tape drive settings are as described in "To configure the tape drive".
3. Remove the chassis cover.
4. Remove the media drive carrier (see
5. Slide the new tape drive into the media drive carrier, and secure it with four undercut
6. Reattach any media drives that you removed to access the tape drive slot.
7. Position the media drive carrier in the media drive bay, leaving enough room to
8. Carefully connect the existing signal and power cables as shown in
9. Slide the carrier into the media drive bay.
10. Secure the media drive carrier to the chassis with four Phillips-head screws.
11. Replace the chassis cover and front bezel.
12. Power on the server.
108 Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Caution:
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
Courtesy down Avaya CallPilot®, and then power down the server.
chassis on page 101).
Phillips-head screws.
Note:
You may need to first remove other media drives from the carrier to access the
tape drive slot.
reach behind the carrier, and attach the connectors.
Cabling example on page 107.
Note:
Ensure that the cables are free and undamaged.
Result:The tape drive is installed.
Result: The tape drive is detected by Windows, and the tape drive is ready for use.
Removing the media drive carrier from the
Figure 28:
December 2010