Table of Contents
Advertisement
Manually setting T1 card manual termination jumpers
Manually set T1 card manual termination jumpers only on the last card at the end of the CTbus.
Important:
Risk of equipment damage
Do not install this jumper on any of the other T1 cards.
Apply a jumper between pins 3 and 4 of the P700 header on the Intel/Dialogic D/
480JCT-2T1 card. The diagram below shows a detail of the T1 card.
Figure 32: D/480JCT-2T1 card
To test the D/480JCT-2T1 card
Test the D/480JCT-2T1 card using the Universal Dialogic Diagnostic (UDD) utility.
Note:
Before running this utility, you must stop essential services. All call processing ceases and
you must restart the system after the diagnostics are complete.
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Manually setting T1 card manual termination jumpers
December 2010
133
Advertisement
Table of Contents
