Copying Parameters - YASKAWA CIMR-ACA4011 Instruction Manual

Copying Parameters

The digital operator can perform the following three functions using the built-in EEPROM (non-volatile mem-
ory).
Store MxC parameter set values in the digital operator (READ)
•
Write parameter set values stored in the digital operator to the MxC (COPY)
•
Compare parameter set values stored in the digital operator with MxC parameters (VERIFY)
•
IMPORTANT
Related Parameters
Parameter
Number
o3-01
o3-02
-128
6
The Matrix Converter is displayed as MxC, and the digital operator is displayed as OP while executing the
COPY function.
Name
Display
Copy Function This parameter controls the copying of
Selection parameters to and from the digital operator.
0: COPY SELECT (no function)
1: INV → OP READ: All parameters are
copied from the MxC to the digital opera-
tor.
2: OP → INV WRITE: All parameters are
copied from the digital operator to the
MxC.
Copy Function Sel
3: OP⇔INV VERIFY: Parameter settings in
the MxC are compared to those in the dig-
ital operator.
Note: When using the copy function, the MxC
model number (o2-04), software num-
ber (U1-14), and control method (A1-
02) must match or an error will occur.
Copy Allowed Enables and disables the digital operator copy
Selection functions.
0: Disabled. - No digital operator copy func-
tions are allowed.
Read Allowable
1: Enabled. - Copying allowed.
Setting
Description
Range
0 to 3
0 or 1
Control Methods
Change
Open
Default during
V/f Loop
Run
Vector
0 No A A
0 No A A
Flux
Vector
A
A