YASKAWA CIMR-ACA4011 Instruction Manual page 384

No. Name
L8-12 Ambient Temperature Setting
OL2 Characteristic Selection at
L8-15
Low Speeds
L8-42 Factory Adjustment 1
n1-01 Hunting Prevention Selection
n1-02 Hunting Prevention Gain Setting
n1-03 Hunting Prevention Time Constant
Speed Feedback Detection Con-
n2-01
trol (AFR) Gain
Speed Feedback Detection Con-
n2-02
trol (AFR) Time Constant
Speed Feedback Detection Con-
n2-03
trol (AFR) Time Constant 2
n5-01 Feed Forward Control Selection
n5-02 Motor Acceleration Time
n5-03 Feed Forward Control Ratio Gain
o1-01 User Monitor Selection
User Monitor Selection After
o1-02
Power-Up
o1-03 Digital Operator Display Selection
Setting unit for frequency parame-
o1-04
ters related to V/f characteristics
o1-05 LCD Brightness Adjustment
Local/Remote Key Function Selec-
o2-01
tion
o2-02 STOP Key Function Selection
o2-03 User Parameter Default Value
o2-04 MxC/kVA Selection
Frequency Reference Setting
o2-05
Method Selection
* 1. The default will change when the control method is changed. The Open Loop Vector defaults are given.
* 2. The defaults depend on the MxC capacity. The values for a 200 V class MxC of 5.5 kW are given.
* 3. These are values for a 200 V class MxC. Values for a 400 V class MxC are double.
* 4. E1-11 and E1-12 are disregarded when set to 0.0.
* 5. E1-13 is set to the same value as E1-05 by Auto-Tuning.
* 6. The defaults in the parentheses are for 3-wire sequence.
* 7. Applicable for the Varispeed AC with software versions PRG: 1050 or later.
* 8. Applicable for the Varispeed AC with software versions PRG: 1052 or later.
Table 10.2 Parameters (Continued) Table 10.2 Parameters (Continued)
Set-
Default No.
ting
Operation Selection when Digital
45 o2-06
Operator is Disconnected
Cumulative Operation Time Set-
1 o2-07
ting
Cumulative Operation Time Selec-
2 o2-08
tion
Initialization Specification Selec-
1 o2-09
tion
1.00 o2-10 Fan operation time setting
Fault Trace/Fault History Clear
10 o2-12
Function
1.00 o2-14 kWh User Monitor Initialization
*7
100 Capacitor maintenance setting
o2-18
750 o3-01 Copy Function Selection
0 o3-02 Copy Allowed Selection
*3
T1-00 Motor Selection 1/2
0.168
1.0 T1-01 Auto-Tuning Mode Selection
6 T1-02 Motor Rated Power
1 T1-03 Motor Rated Voltage
0 T1-04 Motor Rated Current
0 T1-05 Motor Base Frequency
3 T1-06 Number of Motor Poles
1 T1-07 Motor Base Speed
1 T1-08 Number of PG Pulses
0 T1-09 Motor No-Load current
*2
T1-10 Motor Rated Slip
5
0
Parameters
Name Default
0
0
0
0
0
0
0
0
0
0
1
0
*2
5.50
*3
200.0
*2
19.60
60.0
4
1750
600
5.10
1.50
Set-
ting
10
23
10-