Talkswitch 24-CA User Manual page 55

Talkswitch - centrepoint technologies network hardware user manual
Hide thumbs Also See for TALKSWITCH 24-CA:
Table of Contents

Advertisement

and by call bridge. Each hunt group can support several line choices and
attempt to use an available line in the order that they are listed for that
hunt group. These settings have no effect on incoming calls.
Default setup:
Hunt Group 9:
Hunt Group 81:
Hunt Group 82:
Hunt Group 83:
Hunt Group 84:
Hunt Group 88:
1. Select System Information -> Line Hunt Groups.
2. Select a Line Hunt Group and enter a unique Line Hunt Group name to
identify this group elsewhere in the configuration software.
3. Under Set Line Hunt Group, select the Line Type. If you wish to use this
hunt group to access telephone lines, select Phone Lines. To use this hunt
group to access VoIP numbers, select VoIP numbers.
4. Click the checkbox(es) next to the line(s) you wish to add to the hunt
group.
Figure 41: Hunt group configuration
If multiple units are connected to the LAN, outbound calls always hunt
the lines on the unit where the extension is connected. This minimizes
network traffic between units.
T A L K S W I T C H C O N F I G U R A T I O N
selects any available telephone line.
selects telephone Line 1.
selects telephone Line 2.
selects telephone Line 3 (only four-line models).
selects telephone Line 4 (only four-line models).
selects any available VoIP number (only applies
when a VoIP unit is present on the LAN).
4 3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Talkswitch 48-ca/cvaTalkswitch 48-caTalkswitch 48-cva

Table of Contents