Tecal RH5485 Server
Installation and User's Guide
8. Reinstall the front bezel.
If you have other devices to install or remove, do so now. Otherwise, go to"Completing the
installation".
2.13 Installing a 2.5-inch hard disk drive backplane
To install a 2.5-inch hard disk drive backplane, complete the following steps:
1. Read t h e Tecal RH5485 Safety Information.
2. Turn off the server and peripheral devices, and disconnect the power cord and all external
cables.
3. Remove the server cover (see "Removing the top cover" ).
4. Remove the top cover bracket (see "Removing the top-cover bracket").
5. Pull out the hard disk drives and hard disk drive fillers just enough to disconnect them
from the backplane.
6. Remove the ServeRAID adapter from behind the hard disk drive backplane.
7. Disconnect the SAS signal cables from the ServeRAID adapter.
8. Lift the SAS power and configuration cable handle up to disconnect the cables from the
microprocessor board.
9. Slide the backplane carrier release tab forward and slightly lift the carrier.
10. Remove the backplane carrier and SAS power cable handle from the server together.
Issue 02 (2011-05-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
2 Installing optional devices
2-29