Figure 2-43 Locations Of The Input And Output Connectors - Huawei Tecal RH5485 Installation And User Manual

2 Installing optional devices

Figure 2-43 Locations of the input and output connectors

Updating the server configuration
When you start the server for the first time after you add or remove a device, you might
receive a message that the configuration has changed. The Setup utility starts automatically so
that you can save the new configuration settings. For more information, see Chapter 3,
"Configuring the server".
Some optional devices have device drivers that you must install. For information about
installing device drivers, see the documentation that comes with each device.
The server comes with at least one microprocessor. If more than one microprocessor is
installed, the server can operate as a symmetric multiprocessing (SMP) server. You might
have to upgrade the operating system to support SMP. For more information, see "Typical
operating-system installation" and the operating-system documentation.
If the server has an optional RAID adapter and you have installed or removed a hard disk
drive, see the documentation that comes with the RAID adapter for information about
reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see "Configuring
the Broadcom Gigabit Ethernet controller".
2-50 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Tecal RH5485 Server
Installation and User's Guide
Issue 02 (2011-05-25)