Administrator Password - Huawei Tecal RH5485 Installation And User Manual

Tecal RH5485 Server
Installation and User's Guide
If a power-on password is set, you can enable the Unattended Start mode, in which the
keyboard and mouse remain locked but the operating system can start. You can unlock the
keyboard and mouse by typing the power-on password.
If you forget the power-on password, you can regain access to the server in any of the
following ways:


Before you change any switch settings or move any jumpers, turn off the server; then,
disconnect all power cords and external cables. See the safety information that begins on page
vii. Do not change settings or move jumpers on any system-board switch or jumper blocks
that are not shown in this document.

Before you move any jumpers, turn off the server; then, disconnect all power cords and
external cables. See the safety information that begins on page vii. Do not change settings or
move jumpers on any system-board switch or jumper blocks that are not shown in this
document.

Administrator password

If an administrator password is set, you must type the administrator password for access to the
full Setup utility menu. You can use any combination of up to seven characters (A - Z, a - z,
and 0 - 9) for the password.
If you set an administrator password and then forget it, there is no way to change, override, or
remove it. You must replace the I/O board
Issue 02 (2011-05-25)
If an administrator password is set, type the administrator password at the password
prompt. Start the Setup utility and reset the power-on password.
Remove the battery from the server and then reinstall it. For instructions for removing
the battery, see the Problem Determination and Service Guide on the HUAWEI
Documentation CD.
CAUTION
The default for the Password override jumper (J29) is Off.
While the server is turned off, move the jumper to pins 2 and 3 clear the power-on
password override. You can then start the Setup utility and reset the power-on password.
You do not have to return the jumper to the previous position.
The power-on password override jumper does not affect the administrator password.
CAUTION
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
3 Configuring the server
3-7