Table of Contents
Advertisement
3 Configuring the server
3-4
- Acoustic mode
Select this choice to configure the server to draw the minimum amount of power
and generate the least noise. Server performance might be degraded depending on
the application that you are running.
- Performance mode
Select this choice to achieve the highest absolute performance for most server
applications. The power consumption in this mode is often higher than in the
Efficiency or the Acoustics mode.
- Custom mode
Select this choice only if you understand the functions of the low-level IMM
settings. This is the only choice that enables you to change the low-level IMM
settings that affect the performance and power consumption of the server.
−
Integrated Management Module
Select this choice to view or change the settings for the integrated management
module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the server whenever a nonmaskable interrupt
(NMI) occurs. Disabled is the default.
- Commands on USB Interface Preference
Enable or disable the Ethernet over USB interface on IMM.
- Network Configuration
Select this choice to view and select the system management network interface
port, the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address; specify whether to
use the static IP address or have DHCP assign the IMM IP address; save the
network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset the IMM to the default settings.
- Reset IMM
Select this choice to reset the IMM settings.
−
Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does not
support UEFI video output standards.
- Rehook INT
Select this choice to enable or disable devices from taking control of the boot
process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass storage
devices that are not UEFI compliant.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Tecal RH5485 Server
Installation and User's Guide
Issue 02 (2011-05-25)
Advertisement
Table of Contents
