How To Backup / Restore The System Configuration; To Create A Backup File - Honeywell Touchpoint Plus Technical Handbook

9.5 How to Backup / Restore the System Configuration

You should always take a new back up of the Touchpoint Plus system configuration after changes are made

9.5.1 To Create a Backup File

Note: The Touchpoint Plus system must be turned off to change the SD card so alternative safety arrangements
should be put in place prior to starting this procedure.
The TPPL has limited capacity to store events in its onboard memory so do not keep the Event logging SD
1) Login as Administrator.
2) Touch Menu>Maintenance>Power-off>Yes
3) Switch off and isolate the TPPL power supplies.
4) Open the TPPL enclosure door.
5) Temporarily replace the TPPL SD Card with an empty SD card.
6) Close the enclosure door.
7) Switch power back on and wait for the system to stabilise.
8) Login as an Administrator.
9) Touch
Menu>Configuration>Config Manager>Export
10) Enter a file name for the backed-up configuration and touch [Finish].
11) Touch
Export>Yes
take several minutes, and progress is shown on screen.
12) When the backup is completed, touch
13) Switch off and isolate the TPPL power supplies.
14) Open the TPPL enclosure door and replace the backup SD Card with the original or a spare card.
15) Close and secure the enclosure door and return the system to normal operation.
MAN0984_Iss 4_01/19
Pt. No. 3011M5001
and confirmed.
Card out any longer than necessary.
and, if the file name is valid, it will start the configuration backup process. The backup may
Menu>Maintenance>Power-off>Yes
Repairs, Replacements and Upgrades
CAUTION
CAUTION
.
.
116
.
Touchpoint Plus
Technical Handbook