Chapter 9. Repairs, Replacements And Upgrades; How To Decommission And Remove A Serviceable I/O Module; To Remove A Serviceable Module - Honeywell Touchpoint Plus Technical Handbook

Chapter 9.

9.1 How to Decommission and Remove a Serviceable I/O Module

Failing to follow this procedure correctly could render the removed module unusable and unrepairable.

9.1.1 To Remove a Serviceable Module

1) Login as an Administrator or Service.
2) Touch
Menu>Configuration>Module Control panel
3) Touch the I/O module block that you want to remove, and touch [Remove] and confirm [Yes].
4) Wait for the block to turn light blue. Remove any other modules the same way.
5) Touch Menu>Maintenance> Power-off>Yes
6) Isolate the power
7)
8) Electrically disconnect the module(s), and then remove them (see Ch.10.2 How to replace a Faulty Module if you
want to replace it with another module).
9)
10) Close and secure the enclosure door.
11) Switch on the Touchpoint Plus and wait for the system to stabilise.
12) Login as an Administrator or Service.
13) Touch
Menu>Configuration>Module Control panel
14) Touch [Refresh] to confirm the modules were removed correctly.
15) Log out.
MAN0984_Iss 4_01/19
Pt. No. 3011M5001
ANTI STATIC PRECAUTIONS
Antistatic Precautions are required to prevent damage to electronic components.
supplies.
Repairs, Replacements and Upgrades
CAUTION
.
.
-up battery installed).
.
112
-up battery installed).
Touchpoint Plus
Technical Handbook