Honeywell Touchpoint Plus Technical Handbook page 149

Event
Code
Type
Fault 13 Auxiliary battery fault
Fault 14 IO board not matched or present
Cell is producing a negative reading
Fault 15
(depending on gas under-range limit)
Fault 16 Fault self-cleared
Fault 17 Reset all faults by a user
Inhibit 1 Inhibited input channel by LUI
Cleared inhibit mode for input channel by
Inhibit 2
LUI
Inhibit 3 Inhibited all input channels remotely
Cleared inhibit mode for all input channel
Inhibit 4
remotely
Inhibit 5 Detected inhibit input from detector
Warning 1 Battery low (not critical)
Warning 2 Battery is not being charged
Warning 3 RESERVED
Warning 4 Over-range warning
(depending on gas over-range limit)
Warning 5 Calibration is due soon
Warning 6 Time/date not set
MAN0984_Iss 4_01/19
Pt. No. 3011M5001
Long Description
149
Display in Event
Triggered
History
Battery Fault
Main Board
[Enclosure]
IO B/D Not Matched
Main Board Slot: xx-x, Prev: xxx,
Curr: xxx
Negative Reading
Main Board CH: xx, Conc: xxxx
[unit]
Fault Cleared
Main Board
CH: xx, Code: xx
Main Board Reset all faults
Inhibited input
Main Board channel
CH: xx
Cleared inhibit mode
Main Board
CH: xx
Inhibited all channels
Main Board
remotely
Cleared inhibit mode
Main Board remotely
CH: xx
Detector In Inhibit
IO board
CH: xx
Battery is low
Main Board
[Enclosure], xxx %
Battery not charged
Main Board
[Enclosure]
Over range
Main Board CH: xx, Conc: xxxx
[unit]
Calibration is
Main Board overdue
CH: xx, Due: xxxx
Date/Time not set
UI Board
[Date/Time]
Event Codes
Details
Enclosure
0: master enclosure,
1: extension enclosure
Prev, Curr B/D type
0:Main, 1:UI, 2:mA
Input, 3 : mV input,
4:Relay, 5:mA output,
7:Modbus,
7:Extension power
Slot
Refer to the note 1
Code
Code Number (1~17)
Enclosure
0: master enclosure,
1: extension enclosure
Enclosure
0: master and
extension enclosure
Due
Calibration interval -
days passed after
successful calibration
Touchpoint Plus
Technical Handbook