Navigation Active Access Level Icons; Sd Card Usage; User / Component Matrix - Honeywell Touchpoint Plus Technical Handbook

 Eject
 Format
 Power Off 
System Test
 Force Relay 
 Force 4 20 mA 
 Relay C & E Matrix 
 Dedicated Alarm Contacts 
 LCD test 
 LED & Buzzer test 
7.4.1 Navigation Active Access Level Icons
You must enter a valid password to access the menu items listed above. (See Ch.6.3 Logging In/Out.)
The silhouette icon shows who is logged in. Touch the icon to log in / out, or to change to a higher access level:
Note: The system will log you out after a set period of inactivity. (The default authentication timeout is 15 minutes, but
this can be changed in system settings.)

7.5 SD Card Usage

The SD card is used to store the system event history and trend logs. The SD card should remain fitted during normal
operation of the controller to avoid loss of event data.
The card may also be used when backing up and restoring the system configuration.
The Touchpoint Plus accepts standard size SD cards of 2 to 32 GB, using FAT32 formatting. New SD cards must be
formatted by the Touchpoint Plus system when they are first used, as described below. SD cards formatted by
Touchpoint Plus can be used in a standard PC, with an adaptor if necessary, with normal read/write access.
Formatting the SD card deletes all existing data. This is not reversible.
SD cards must be write-enabled before use.
Touchpoint Plus monitors the SD card use and warns the user when there is less than 50MB of free space remaining,
and when the SD card is full.
If the SD card is not replaced or more space made available, the Touchpoint Plus continues to log data by overwriting
the oldest data. Overwritten data is not recoverable. A further warning is given when data is being overwritten,
The SD card icon on the front panel changes to yellow if the Touchpoint Plus is unable to save data or the SD card is
being overwritten.
The system will continue to function correctly as a controller if there is no SD card fitted or data cannot be saved. The
safety function is not affected.
To avoid fragmentation of logged data, only one SD card should be in use at any time. If the SD card is removed, it
should not be temporarily replaced by another SD card as event data will be logged on the replacement card until the
original card is returned. The data stored on the temporary card cannot be used by the Touchpoint Plus.
Data will be cached for up to 5 minutes when the SD card is removed, and written to the SD card when it is replaced.
Data will be lost if the SD card is not replaced within this time.
MAN0984_Iss 4_01/19
Pt. No. 3011M5001
Menu Item
Table 14.
No one is logged in
Operator is logged in
Service engineer is logged in
Administrator is logged in
Admin. Service
 
 
 
 
 
 
 
 
 
 

User / Component Matrix

85
Operator Others
 
 
 
 
 
 
 
 
 
 
Touchpoint Plus
Technical Handbook