Table of Contents
Advertisement
Downloading Datalogs and Performing PC-Based Instrument
Configuration and Firmware Upgrades
The MultiRAE communicates with a PC running Safety Suite Device Configurator (SSDC)
software to download datalogs, configure the instrument, or upgrade the instrument's firmware.
Note: The most recent version of Safety Suite Device Configurator (SSDC) software is available
for a free-of-charge download at: https://explore.honeywell.com/safety_suite_device_
configurator.html
The MultiRAE must be connected to a PC through the supplied Desktop Cradle, Travel Charger,
or AutoRAE 2 and must be in the PC or AutoRAE 2 communications mode.
Desktop Cradle or Travel Charger
1.
Use the supplied PC Communications Cable (USB to mini-USB cable) to connect the
Desktop Cradle or Travel Charger to a PC.
2.
Turn on the MultiRAE. Make sure it is running in Normal mode (with the main
measurement screen showing).
3.
Insert the MultiRAE in the Desktop Cradle or connect it to the Travel Charger.
4.
Activate the PC communications mode on the MultiRAE by pressing [N/-] repeatedly,
starting from the main measurement screen until you reach the "Communicate With
Computer?" screen.
5.
Press [Y/+]. Measurement and datalogging stop, and the instrument is now ready to
communicate with the PC. The display now says "Ready To Communicate With
Computer."
6.
Start up the Safety Suite Device Configurator (SSDC) software, enter a password, and
detect the instrument following the directions provided in the Safety Suite Device
Configurator (SSDC) User's Guide.
7.
Follow the instructions in the Safety Suite Device Configurator (SSDC) User's Guide to
download the datalog, configure the instrument settings, or update the MultiRAE's
firmware.
8.
When you are done, press [Y/+] to exit the PC communications mode on the MultiRAE.
The instrument returns to operating in Normal mode.
Honeywell MultiRAE Series™
139
User Manual
Advertisement
Table of Contents
