Figure 2-34 Trigger Level Pop-Up - Keysight Technologies N8262A P Series User Manual

2 General Power Meter Functions
The trigger source is shown beside the trigger symbol when a measurement
window is configured in single numeric mode. When an external trigger (
selected, the power meter can be triggered via the Ext Trig input.
Mode
Source Ch.B
To change the setting press
The current setting is displayed below the label. When
choose the RF power level transition used as the trigger. The power meter
automatically finds a triggering power level transition when
Level
current value is shown below the
enter is limited to 40 dB below the maximum sensor power. To change the setting
press
Trigger Level pop-up window to enter the new value.
Figure 2-34
Complete the entry by pressing
Delay
applied between the trigger event and all the gate start times. This allows you to
time-shift all the gates by the same amount with one setting change. A delay of
up to 1 second can be entered. To enter or change the setting press
78
The key is only available when trigger
Mode
is selected.
is only available when
Level
and use the numeric softkey pad to enter the required value in the
Level
Trigger Level pop-up
The current setting is displayed below the
and choose
Mode Norm
trigger mode has been selected. The
Norm
label. The minimum power level you can
Level
.
dBm
or
Source Ch.A
or .
AutoLvl
is selected you can
Norm
is selected.
AutoLvl
label. The delay time is
Delay
Delay
Keysight N8262A User's Guide
) is
Ext
and