Keysight Technologies N8262A P Series User Manual page 55

1 Select the table to be applied to a channel. Refer to
2 If using an 8480 Series or an E-Series Sensor, zero and calibrate the power
3 Specify the frequency of the signal you want to measure. The calibration
4 Make the measurement.
Selecting a frequency dependent offset table
You can select a frequency dependent offset table from the
followed by
The State column indicates if any frequency dependent offset tables are currently
selected. The Offset Tables screen is shown in
NOTE
You can also view which FDO table is being used by clicking the
Offsets
and click
Procedure
Select an offset table as follows:
1 Click, either:
Keysight N8262A User's Guide
dependent offsets" on page 54 for further information. If you require to edit the
table refer to "Editing frequency dependent offset tables"
further information.
meter. The reference calibration factor used during the calibration is
automatically set by the power meter from the sensor calibration table (if
selected).
factor/offset is automatically set by the power meter from the sensor
calibration table (if selected) and the frequency dependent offset table. Refer
to "Procedure" on page 55 for further information.
and
Tables
and use the
to display the table.
a ,
Tables
General Power Meter Functions
.
Freq. Dep. Offset
and softkeys to highlight the FDO Table setting field
, .
Freq. Dep. Offset
"Setting frequency
on page 57 for
Figure 2-13.
2
softkey menu
,
55