Troubleshooting - EdilKamin KIRA H 18 Installation, Use And Maintenance Manual

If problems occur, the product shuts itself off automatically.
The display will show the reason (see below).
Do not disconnect from the power supply.
To start the product up again, allow the shut-down procedure to complete, then press the
ON/OFF button.
Before starting the product up again, check the reason for the shutdown and CLEAN THE
GRATE.
The product is equipped with a safety valve but, if the grate is not cleaned regularly as
explained above, ignition may involve a small detonation. If white smoke forms in the
combustion chamber for a long time, disconnect the mains supply and wait 30 minutes
before opening the door and emptying out the grate.
sHUtDoWn MessAGes AnD tHeIR soLUtIons:
MessAGe PRobLeM
displays when the combustion
H01
air intake is below the set level
displays when the logic board
H02 does not detect the correct
smoke fan speed
displays when the thermocouple
detects a smoke temperature
H03 lower than the set value and
interprets this as the absence of
flame
displays when ignition times out
H04
unsuccessfully
Shut down due to air flow rate
H05
sensor breakage
displays when the logic board
determines that the smoke
H06
temperature probe is broken or
disconnected

tRoUbLesHootInG

soLUtIon
• Check that the combustion chamber door is closed
• Check the regular maintenance of the stove
• Check that smoke discharge and combustion air
ducts are clean.
• Contact the technician
• Check that there are pellets in the tank
• Check if the water temperature has increased due to
the closing of a valve (contact the technician)
• Contact the technician
There are two possibilities:
NO flame:
• Check that the grate is seated properly and is clean
• Check that there are pellets in the tank and grate
• Use a piece of solid paraffin to light the stove (contact
the technician first)
Flame present:
• Contact the technician
• Contact the technician
• Contact the technician
UseR/InstALLeR
47