Maintenance; Daily Maintenance - EdilKamin KIRA H 18 Installation, Use And Maintenance Manual

Disconnect the product from the power supply.
Failure to service the product properly will prevent it from working properly.
Any problems due to failure in servicing the stove will void the warranty.

DAILy MAIntenAnce

These operations must be done with the product off,
cold and preferably disconnected from the mains.
A suitable vacuum cleaner is required.
The entire procedure takes just a few minutes.
Operations are represented in the figures whose
numbers correspond to the instructions on this page.
Using the stove without cleaning the grate can cause the gas in the combustion
chamber to ignite and detonate.
DAILy MAIntenAnce
1. Activate the cleaning brushes under the lid of the pellet load.
2. Open the combustion chamber door (P) using the protective lever (removable handle)
3. Empty the ash tray (B) and the grate (C) into a non-flammable container (the ashes may still contain embers and/
or hot parts, or clean using a vacuum cleaner if cold. Vacuum out the interior of the fireplace, the bed, and the
compartment around the grate into which the ash falls.
4. Scrape the grate with the provided scraper and clean out any obstructed holes.
5. Clean the glass (when cold) if necessary, by using a suitable product (such as Glasskamin) available at the
retailer.
1
2
P

MAIntenAnce

c
b
UseR/InstALLeR
Do not dump the cleaning residue into the pellet tank.
Once it is refitted, make sure that the ash tray is properly
placed in its housing, to avoid glass breakage when
closing.
Make sure that the grate is properly placed in its housing
after maintenance operations, if not, the stove may have
ignition problems.
3
b
c
45