Terminal Board - EdilKamin KIRA H 18 Installation, Use And Maintenance Manual

teRMInAL boARD

On the rear (after having removed the protective cover
that is fixed with two screws), there is a bracket with 2
terminal boards and 5 cable glands*.
One terminal board (10 poles) is low voltage and the
other (6 poles) is high voltage. You can find some
connection examples below.
* The cable glands are included in the bag on top of
the product structure. According to the connections
needed on the terminal board, break the half-part on
the cover of the terminal board where the cable is to be
connected and block it with the cable gland.
Poles are identified with a number on the product as described below
low voltage terminal board
14
N o .
PossIbLe connectIons
PoLes
NTC analogue input
1/2
3/4 NTC probe/accumulator tank thermostat
5/6 NTC probe/room thermostat
Home Automation Input.
7/8 This is an input which receives all home automation
contacts
9/10 Probe for domestic hot water boiler
high voltage terminal board
N o .
PossIbLe connectIons
PoLes
Electrical connection for booster/secondary pump
1/2/3
(Earth, Neutral/Phase)
EXTERNAL SOLENOID VALVE (Common, Normally
Closed, Normally Open)
4 = Common
4/5/6
5 = Normally Closed
6 = Normally Open
teRMInAL boARD
notes
e.g. for a second probe for accumulator tank or
boiler for domestic hot water or for an external
probe for climatic curve
the room probe is supplied already wired as
standard
A telephone dialler, for example
notes
During First Ignition, the technician can set up,
into parameters, the connection setting on points
4 and 5, of an external boiler contact or remore
alarm.
InstALLeR