EdilKamin KIRA H 18 Installation, Use And Maintenance Manual page 10

tHe exHAUst PIPe to be connecteD
to tHe fUMe MotoR Is LocAteD In tHe
pELLET TANK.
1. Open the lid of the pellet tank and take the pipe
2. : remove the right side panel when viewing the stove from the front. To remove it,
foR VyDA H
unscrew the two upper screws and remove it from the snap fastening below.
3. Unscrew the three screws securing the centring bracket to the back of the stove
10
4.Push one end out from the back of the stove and fit the pipe onto the fume motor.
Reposition and the centring bracket screw it to the back of the stove
connectInG tHe fUMe exHAUst PIPe
staffa di centraggio
InstALLeR
The drawings are for guidance only, useful for
the installation, but they may not refer to the
specific model.