Table of Contents
Advertisement
im Vertrieb von
Installation
Installation Overview
CAUTION
1
2
3
4
5
6
7
8
2U Rack Enclosure
Removable Side Panel
(to access cable channel)
Cable Tie Holes
www.camboard.de
2-2
MLM-WB+ • Installation
CAMBOARD Electronics
All installation and service procedures should be performed by an Extron
authorized installer or a qualified electrician. Extron is not responsible for
equipment failure or damage occurring as a result of improper installation.
Contact a contractor or hardware specialist for assistance with the installation.
Your installation may require additional hardware beyond what Extron
provides with the MLM-WB+.
Identify components and mounting hardware for the MLM-WB+ and obtain
the tools required for installation. See Components, Hardware, and Required Tools
in this chapter.
Select the installation site. On nonmasonry walls, the MLM-WB+ must be
attached to at least one stud. The installation is sturdiest if the wall box is
attached to two wall studs or to a concrete/masonry wall.
Mount the outer enclosure onto the wall and route power cables into the
junction box inside the MLM-WB+.
Wire power cables to the duplex receptacles, and secure the receptacles and
junction box cover to the junction box.
Route the audio, video, control, and power cables through the small
rectangular openings on top of the MLM-WB+. Remove the left and right side
panels and continue routing these cables to the lower part of the enclosure.
See Routing Cables into the MLM-WB+ in this chapter.
Install all devices in the MLM-WB+ 2U and 4U rack enclosures. To do this,
perform the setup procedure (if applicable) for each A/V device to be installed
and then connect power and A/V cables to all equipment. See Installing
Equipment in this chapter.
Test all equipment. Make adjustments to settings and cabling as needed. Be
sure to disconnect power from all equipment before making wiring changes.
Failure to disconnect power from the computer, input and output devices,
or any controllers while adjusting the wiring can result in injury (electric
shock) and/or equipment damage.
Secure all equipment in the 2U and 4U rack enclosures.
Slotted Clevis Bracket
(for door leveling adjustment)
Adjustable Clamp Brackets
Tel. 07131 911201
Fax 07131 911203
12" & 16" OC Spaced Mounting Slots
Extension Damper
Cable Opening (2 per side)
Work Space/
Equipment Cover (Max. 15 lb)
Rubber Stop
4U Rack Enclosure
ce-info@camboard.de
Advertisement
Table of Contents
