Table of Contents
Advertisement
im Vertrieb von
Installation, cont'd
Included mounting hardware
Required tools
To install the MLM-WB+ you will need the following tools:
•
Phillips screwdriver
•
Flat head screwdriver
•
Drill with drill bits
•
Level
Adjusting the Door Angle
Before mounting the MLM-WB+, ensure that the door opens to the proper angle.
To adjust the door angle, if necessary:
1.
2.
3.
4.
Sliding the clevis brackets to adjust the door angle
www.camboard.de
2-4
MLM-WB+ • Installation
CAMBOARD Electronics
(4) 1/4-20 x 2"
Pan Head Bolts
#40-375-01
(4) 1/4" Kap Toggle Assemblies
#40-374-01
Set the MLM-WB+ upright on a flat surface and open the door.
Partially loosen, but do not remove, the screws holding the clevis brackets to
the door.
Slide the clevis brackets:
Forward, to make the door open to a higher position, or
Backward, to make the door open to a lower position.
Tighten the screws.
Tel. 07131 911201
Fax 07131 911203
(6) 1/4" x 1 3/4" Masonry Screws
#40-373-01
(6) #14 x 1 3/4" Self-tapping Metal/Wood Screws
#40-372-01
(6) 1/4" x 1" O.D., 5/16" I.D. Metal Washers
#40-376-01
•
Pencil
•
3/8" wrench or ratchet
•
Wire cutter
ce-info@camboard.de
Advertisement
Table of Contents
