Extron electronics MediaLink MLM-WB+ User Manual page 14

im Vertrieb von
Installation, cont'd
6.
7.
8.
Installing toggle bolts
CAUTION
www.camboard.de
2-8 MLM-WB+ • Installation
CAMBOARD Electronics
Drill pilot holes in the wall at the locations you marked in step 4.
• If drilling into a stud, make each hole 1.75" (4.4 cm) deep.
• If drilling into the wall where no stud is present, make each hole through
to the hollow part of the wall.
Install a self-tapping screw and washer in each slotted mounting hole (
location lined up with a wall stud:
Prepare the screw for installation by inserting it through a flat metal
a.
washer (1" [2.5 cm] outer diameter and 0.25" [0.6 cm] inner diameter).
b. Insert the screw and washer into one of the pilot holes on the wall.
At this time, only install screws that line up with slotted mounting holes on
the MLM-WB+.
c. Securely fasten the screw into the wall until a gap of 1/8" to 3/8"
(3 to 9 mm) remains between the wall and the metal washer.
d. Repeat these steps until all self-tapping screws have been installed for
slotted mounting hole locations.
Install toggle bolts (if required) as follows:
a. While holding the plastic handle, collapse the toggle assembly and insert
it into the wall through one of the pilot holes.
b. Secure the toggle assembly by sliding the plastic washer down the plastic
handle into the pilot hole in the wall.
Using a cutting tool, cut off the plastic handle close to the plastic washer
c.
in the wall. The plastic washer creates a threaded hole for a toggle bolt.
d. Insert a pan head bolt through a metal washer and then into the threaded
hole until a gap of 1/8" to 3/8" (3 to 9 mm) remains between the metal
washer and the wall.
a.
c.
Install the toggle bolt by hand; do not use a power tool. The use of a power
tool may create too much pressure, causing the toggle assembly's plastic
washer to break. If this happens, the toggle assembly will fall into the wall.
e. Repeat these steps until all toggle bolts have been installed.
Tel. 07131 911201
Fax 07131 911203
b.
d.
ce-info@camboard.de
)