Table of Contents
Advertisement
im Vertrieb von
Mounting the MLM-WB+ on a nonmasonry wall
Level
www.camboard.de
CAMBOARD Electronics
6.
Align the slotted mounting holes (
back of the MLM-WB+ with the screws in the
wall. Move the MLM-WB+ forward over the
washers and down as shown at right.
Insert a masonry screw and washer through
7.
each round mounting hole on the MLM-WB+
enclosure for which you drilled a pilot hole.
8.
Tighten all masonry screws to secure the unit to the wall.
On nonmasonry walls, the MLM-WB+ must be attached to at least one stud.
1.
Locate the wall stud(s) in the area where you will install the MLM-WB+, and
use a pencil to mark their locations on the wall.
2.
With the help of at least one other person, hold the MLM-WB+ against the
wall so that the mounting holes line up with the stud(s) as follows:
•
If two wall studs are accessible, align the slotted and round mounting
holes on the back of the MLM-WB+ with the studs as shown in the
illustration below (choose either option A or option B).
•
If only one wall stud is accessible, align the round mounting hole in the
center of the MLM-WB+ with the stud as shown in the illustration below
(option C).
16" (40.6 cm)
A
Options for securing the MLM-WB+ to wall studs (view of rear panel as
seen from the front)
3.
Use a carpenter's level or similar tool as a guide for leveling the unit.
4.
When the MLM-WB+ is level and properly aligned with the stud(s), mark the
locations of the slotted and round mounting holes on the MLM-WB+
(indicated by + marks in the illustration above).
If you are mounting the MLM-WB+ to only one stud (option C) also mark the
slotted holes indicated by the the four x marks to add toggle bolts to increase
the installation's stability and strength.
5.
Set the MLM-WB+ aside.
Tel. 07131 911201
Fax 07131 911203
) in the
A
+
12" (30.5 cm)
B
ce-info@camboard.de
MLM-WB+ • Installation
B
+
C
2-7
Advertisement
Table of Contents
