Extron electronics MediaLink MLM-WB+ User Manual page 20

im Vertrieb von
Installation, cont'd
2.
3.
CAUTION
4.
5.
6.
Securing equipment using clamp brackets
www.camboard.de
2-14 MLM-WB+ • Installation
CAMBOARD Electronics
Remove the screws attaching the adjustable clamp brackets to the inside of the
enclosure. Set the brackets and cover aside.
Stack equipment on the door, making sure not to exceed the maximum
equipment height of 5.5" (14.0 cm) or the maximum rack depth of 16.0"
(40.6 cm).
Be careful not to scrape the equipment against the door's cam lock.
Remove rubber feet from the bottom of any equipment you are mounting using
rack ears.
You can use custom rack shelves to mount equipment such as VCRs and DVD
players in the 4U enclosure (Extron does not supply these shelves).
Attach power and A/V cables to all equipment.
Trim back any exposed cable shields (braids or foil) or insulate them with heat
shrink.
To prevent short circuits, the outer foil shield can be cut back to the point
where the cable exits a cable clamp. Both braided and foil shields should be
connected to an equipment ground at the other end of the cable.
Secure the equipment in the rack by doing one or both of the following:
• Attaching one or both of the clamp brackets removed earlier.
pt op
La
D V D D
D V
V C R
Y
DIS PLA R
WE
PO
LU ME ME LU
VO VO
/
MAX
MIN
Clamp
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de